42
When TIMER indicator is flashing
The unit will be overheated when TIMER indicator is flashing.
Due to a problem in the speaker circuit, the unit will enter the stand-by mode
automatically.
In this case, take the following corrective actions.
1. Unplug the AC power plug from the AC outlet.
2. Make sure that the unit vent is not blocked.
3. Make sure that the speaker wires have been correctly connected to the
speaker terminals.
4. After checking items 2 and 3 above, wait for 2 or 3 hours before trying to use
the unit.
5. Reconnect the AC power cord.
Note:
If the TIMER indicator flashes again during use, please unplug the AC power plug,
and contact a SHARP authorized service center.
References
– Troubleshooting Chart –
Troubleshooting Chart (continued)
■ Before transporting the unit
1. Press the POWER button to turn the power on.
2. Press the CD button.
3. Press the
77
77
7 OPEN/CLOSE button to open the disc tray.
Remove all CDs inserted the unit.
4. Press the
77
77
7 OPEN/CLOSE button to close the disc tray.
Make sure that “NO DISC” is displayed.
5. Press the POWER button to enter the stand-by mode, and then unplug the
AC power cord from the AC outlet.
■ Clearing all the memory (reset)
1. Press the POWER button to enter the power stand-by mode.
2. While pressing down the
00
00
0 /
RR
RR
R button and X-BASS/DEMO button, press
the POWER button until “CLEAR AL” appears.
Caution:
This operation will erase all data stored in memory including clock, timer settings,
tuner preset, CD program, and other set-up details.
To Next Page
Loading...
Need help?
General
