Sharp CD-DP2400E - Radio Operation; Listening to the Radio

19
CD-DP2400E_2.fm01/7/17
CD-DP2400E
Radio
- Listening to the radio -
Listening to the radio
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
"
"" will appear when an FM broadcast is in stereo.
"
If the FM reception is weak, press the TUNER (BAND) button to extinguish the
"ST" indicator. The reception changes to monaural, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3
Press the TUNING/TIME ( or ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING/TIME button as many times as required to tune in to the de-
sired station.
Auto tuning:
When the TUNING/TIME button is pressed for more than 0.5 seconds, scanning
will start automatically and the tuner will stop at the first receivable broadcast sta-
tion.
Notes:
"
When radio interference occurs, auto scan tuning may stop automatically at
that point.
"
Auto scan tuning will skip weak signal stations.
"
To stop the auto tuning, press the TUNING/TIME button again.
FM stereo mode indicator
FM stereo receiving indicator
Downloaded from: http://www.usersmanualguide.com/