20
CD-DP2400E_2.fm01/7/17
CD-DP2400E
Radio
- Listening to the memorised station -
Listening to the memorised station
!
Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a but-
ton. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.
!
To recall a memorised station
!
To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)
!
To erase entire preset memory
1
Perform steps 1 - 3 in "Listening to the radio" on page 19.
2
Press the MEMORY/SET button to enter the preset tuning saving
mode.
3
Within 30 seconds, press the PRESET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY/SET button to store that
station in memory.
If the "MEMORY" and preset number indicators go out before the station is mem-
orised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
When a new station is stored in memory, the station previously memorised will
be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to select
the desired station.
Preset channel Frequency and frequency band
1
Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be tuned in se-
quentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the desired station
is located.
1Press the ON/STAND-BY button to enter the power stand-by mode.
2Whilst pressing down the TUNER (BAND) button and the X-BASS/DEMO button,
press the ON/STAND-BY button until "TUNER CL" appears.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
