21
CD-DP2400E_3.fm01/7/17
CD-DP2400E
Tape Playback
- Listening to a cassette tape (TAPE 1 or TAPE 2) -
Listening to a cassette tape (TAPE 1 or TAPE 2)
Playback is possible in the TAPE 1 compartment as well as in TAPE 2.
To stop playback:
Press the (TAPE ) button.
Fast forward/rewind: (TAPE 2 only)
Caution:
!
To remove the cassette, press the (TAPE ) button, and then open the compart-
ment.
!
Before changing from one tape operation to another, press the (TAPE ) button.
!
If a power failure occurs during tape operation, the tape head will remain engaged
with the tape and the cassette door will not open. In this case, wait until the power
is restored.
Before playback:
!
For playback, use normal or low-noise tapes for the best sound.
(Metal or CrO tapes are not recommended.)
!
Do not use C-120 tapes or poor-quality tapes, as they may cause mal-
functions.
!
Before loading a tape into the cassette compartment, tighten the slack
with a pen or a pencil.
1
Press the ON/STAND-BY button to turn the power on.
2
Open the cassette door by pushing the area marked " PUSH
EJECT".
3
Load a cassette into the TAPE 1 or TAPE 2
cassette compartment with the side to be
played facing toward you.
4
Press the TAPE (1 2) button to select the cassette you want to
listen to.
5
Press the / button to start playback.
When playing back using the remote control, press the TAPE 1 or TAPE 2 but-
ton.
1Press the (TAPE ) button, then press the TAPE (1 2) button to select TAPE 2.
2To advance the tape, press the ( / ) button. To rewind it, press the (
/ ) button.
TAPE 1 TAPE 2
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
