9
CD-DP2400E_1.fm01/7/17
CD-DP2400E
Preparation for Use
- Remote control -
Remote control
"
Battery installation
Precautions for battery use:
!
Replace all old batteries with new ones at the same time.
!
Do not mix old and new batteries.
!
Remove the batteries if the unit will not be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
!
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
!
Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
!
Replace the batteries if the operating distance is reduced or if the operation
becomes erratic.
!
Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
!
Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
!
Keep the remote control away from moisture, heat, shock, and vibrations.
"
Test of the remote control
Check the remote control after checking all the connections (see pages 10 - 12).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy the
music.
Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
Batteries are not included.
1Remove the battery cover.
2Insert the batteries according to the direction indicated in the bat-
tery compartment.
When inserting or removing the batteries, push them towards the battery termi-
nals.
3Replace the cover.
0.2 m - 6 m
(8" - 20')
Remote sensor
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
