Sharp CD-DP2400E - Recording from Radio and Dubbing Tapes; Erasing Recorded Tapes

23
CD-DP2400E_3.fm01/7/17
CD-DP2400E
Tape Recording
- Recording to a cassette tape -
"
Recording from the radio
To interrupt recording:
Press the REC/PAUSE ( ) button.
To resu me recording, press the / (TAPE 2 ) button.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
"
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will simultaneously stop.
"
Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1
Tune in to the desired station (see page 19).
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC/PAUSE ( )
button.
Recording will be paused.
4
Press the / button on the
main unit or the TAPE 2 but-
ton on the remote control to
start recording.
Erase-prevention tabs on cassette tapes:
!
When recording on a cassette tape, make
sure that the erase-prevention tabs are not
removed. Cassettes have removable tabs
that prevent accidental recording or erasing.
!
To protect the recorded sound, remove the
tab after recording. Cover the tab hole with
the adhesive tape to record on the tape with-
out the tab.
Tab for side B Tab for side A
Side A
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into
the TAPE 1 cassette compart-
ment. Insert a blank tape into the
TAPE 2 cassette compartment.
It is recommended that the recording
tape is the same length as the master
tape.
3
Press the TAPE (1 2) button un-
til "TAPE 1" appears on the dis-
play.
4
Press the REC/PAUSE ( ) but-
ton.
Recording will be paused.
5
Press the / button on the
main unit or the TAPE 2 button
on the remote control to start
dubbing.
1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2Press the TAPE (1 2) button until "TAPE 2" appears on the display.
3Press the REC/PAUSE ( ) button.
4Press the / button on the main unit or the TAPE 2 button on the remote con-
trol to start erasing.
Downloaded from: http://www.usersmanualguide.com/