EasyManua.ls Logo

Sharp CD-DP2500H - Setting the Clock

Sharp CD-DP2500H
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
SETTING THE CLOCK
In this example, the clock is set for the 24-hour (0:00) system.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Press the CLOCK button.
3 Within 5 seconds, press the MEMORY/SET button.
4 Press the TUNING/TIME (X or W) button to select the time
display mode.
“0:00” The 24-hour display will appear.
(0:00 - 23:59)
“AM 0:00” The 12-hour display will appear.
(AM 0:00 - PM 11:59)
“AM 12:00” The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first in-
stalled or it has been reset (see page 32).
5 Press the MEMORY/SET button.
6 Press the TUNING/TIME (X or W) button to adjust the hour.
Press the TUNING/TIME (X or W) button once to ad-
vance the time by 1 hour. Hold it down to advance con-
tinuously.
When the 12-hour display is selected, “AM” will change
automatically to “PM”.
7 Press the MEMORY/SET button.
8 Press the TUNING/TIME (X or W) button to adjust the min-
utes.
Press the TUNING/TIME (X or W) button once to ad-
vance the time by 1 minute. Hold it down to change the
time in 5 minute intervals.
The hour setting will not advance even if minutes advance
from “59” to “00”.
9 Press the MEMORY/SET button.
The clock starts operating from “0” second.
(Seconds are not displayed.)
And then the clock display will disappear after a few sec-
onds.
To see the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The clock display will flash on and off at the push of the
CLOCK button when the AC power supply is restored after
a power failure occurs or after the AC power lead is discon-
nected.
If this happens, follow the procedure below to change the
clock time.
To change the clock time:
1
Press the CLOCK button.
2 Within 5 seconds, press the MEMORY/SET button.
3
Perform steps 6 - 9 above.
To change the time display mode:
1
Perform steps 1 - 2 in the section “RESETTING THE MI-
CROCOMPUTER”, on page 32.
2
Perform steps 1 - 9 above.
(Main unit operation)
Downloaded from: http://www.usersmanualguide.com/

Related product manuals