17
RADIO OPERATION
■ Tuning
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the desired fre-
quency band. (FM ST, FM or AM)
4 Press the TUNING/TIME (X or W) button to tune into the
desired station.
Manual tuning:
Press the TUNING/TIME (X or W) button as many times
as required to adjust the frequency shown on the display to
the frequency of the desired station.
Auto tuning:
When the TUNING/TIME (X or W) button is pressed for
more than 0.5 seconds, scanning will start automatically and
the tuner will stop at the first receivable broadcast station.
Notes:
● When radio interference occurs during auto scan tuning,
auto scan tuning may stop automatically at that point.
● If a weak station signal is found during auto scan tuning,
the station will be skipped.
● To stop the auto tuning, press the TUNING/TIME (X or
W) button again.
● When an RDS (Radio Data System) station is tuned in,
the frequency will be displayed first, and then the RDS
indicator will light, Finally, the station name will appear.
5 To receive an FM stereo transmission, press the TUNER
(BAND) button so that the “ST” indicator on the display lights
up.
● “j” will appear when an FM broadcast is in stereo.
6 If the FM reception is weak, press the TUNER (BAND) but-
ton so that the “ST” indicator goes out.
● Although the reception changes to monaural, the sound
becomes clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Note:
● The last station tuned in will be recalled, even after chang-
ing the tuning band or the function, or after switching the
unit to the stand-by mode.
(Main unit operation)
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
