Sharp CD-DP2500H - How to Use the Built-In Timer

30
HOW TO USE THE BUILT-IN TIMER
● Before setting the timer, make sure that the clock setting is
correct. (Page 11)
■ Timer playback
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CD, TUNER (BAND), TAPE (1 V 2) or VIDEO/
AUX (1 V 2) button to select the desired function, and then
adjust the sound volume using the VOLUME control.
3 Press the TIMER/SLEEP button repeatedly until “f PLAY”
is displayed.
● The timer set indicator will flash.
4 Press the TUNING/TIME ( X or W ) button to set the hour
start time, then press the MEMORY/SET button.
5 Press the TUNING/TIME ( X or W ) button to set the
minute start time, then press the MEMORY/SET button.
● The unit will enter the stand-by mode automatically, then
the timer set indicator will light up and finally “f PLAY”
will disappear.
6 When the preset time is reached, the timer playback will start.
● The volume will increase gradually.
7 If you select CD or TAPE, the unit will enter the stand-by
mode after the playback. If you select TUNER or VIDEO/
AUX, it will enter the stand-by mode one hour after the timer
playback starts.
Note:
● When performing timer playback using an external unit con-
nected to the VIDEO/AUX (1 or 2) socket, only the power of
the main unit will be turned off automatically. (The power of
the external unit will not be turned off.)
■ Timer recording
1 Press the ON/STAND-BY button to turn the power on.
● Load a cassette for recording into the TAPE 2 cassette
compartment.
2 Press the TUNER (BAND) or VIDEO/AUX (1 V 2) button to
select the desired function, and then adjust the sound vol-
ume using the VOLUME control.
3 Press the TIMER/SLEEP button repeatedly until “f REC”
is displayed.
● The timer set indicator will flash.
4 Press the TUNING/TIME ( X or W ) button to set the hour
start time, then press the MEMORY/SET button.
5 Press the TUNING/TIME ( X or W ) button to set the
minute start time, then press the MEMORY/SET button.
● The unit will enter the stand-by mode automatically, then
the timer set indicator will light up and finally “f REC” will
disappear.
6 When the preset time is reached, the timer recording will
start.
● The volume will increase gradually.
7 When the recording tape reaches its end, the timer record-
ing will end, and the unit will enter the stand-by mode.
To cancel timer operation:
Press the ON/STAND-BY button to turn the power on.
To change the programmed contents:
Start again from step 1.
Note:
● Once the time is set, the setting will be retained until a new
time is entered.
(Main unit operation)
Timer set indicator
Timer set indicator
(Main unit operation)
Downloaded from: http://www.usersmanualguide.com/