29
(Continued)
■ Recording from the built-in radio
1 Tune in to the desired station. (See pages 17-18.)
2 Load a cassette into the TAPE 2 cassette compartment.
3 Press the REC PAUSE (● 6) button.
● “REC” will flash.
4 Press the 0/R (TAPE 2 0) button.
● “REC” will appear.
Note:
● If a whistling noise is heard whilst recording from an AM
station, move the AM loop aerial to a position where noise
is no longer heard from the unit.
To stop recording:
Press the ■ (TAPE ■) button.
■ Dubbing from tape to tape
1 Press the ON/STAND-BY button to turn the power on.
2 Load a prerecorded cassette into the TAPE 1 cassette com-
partment. Insert a blank tape into the TAPE 2 cassette com-
partment.
● It is recommended that the recording tape be the same
length as the master tape.
3 Press the TAPE (1 V 2) button until “TAPE 1” appears in
the display.
4 Press the REC PAUSE (● 6) button.
5 Press the 0/R (TAPE 2 0) button.
To stop dubbing:
Press the ■ (TAPE ■) button.
● TAPE 1 and TAPE 2 will simultaneously stop.
■ Erasing recorded tapes
● Make sure that TAPE 1 is not in use.
1 Load the tape to be erased into the TAPE 2 cassette com-
partment.
2 Press the TAPE (1 V 2) button until “TAPE 2” appears in
the display.
3 Press the REC PAUSE (● 6) button.
4 Press the 0/R (TAPE 2 0) button.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
