Sharp CD SW340

03/12/17 CD-SW340 02-43.fm
34
CD-SW340
Advanced Features
Timer and sleep operation (Remote control only) (continued)
 Sleep operation
The radio, CD, MP3/WMA disc and cassette tape can all be turned
off automatically.
To confirm the remaining sleep time:
To cancel the sleep operation:
Press the ON/STAND-BY button while “SLEEP” is indicated.
To cancel the sleep operation without setting the unit to the stand-by
mode, proceed as follows.
 To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD in the next morning.
Sleep and timer recording:
For example, you can fall asleep listening to the CD and record radio
programs while sleeping.
Caution:
When using the cassette deck, be sure the tape length is long
enough to perform both functions. If you want to sleep and wake up
listening to a tape, and the length of the tape is shorter than the sleep
timer setting, timer playback or recording will not be possible.
1 Play back the desired sound source.
2 Press the CLOCK/TIMER button.
3 Within 10 seconds, press the
or button to select
“SLEEP”, and press the
MEMORY button.
4 Press the or button to select the time.
(Maximum: 3 hours - Minimum: 1 minute)
 3 hours - 5 minutes 5-minute intervals
 5 minutes - 1 minute 1-minute intervals
5 Press the MEMORY button.
“SLEEP” will appear.
6 The unit will enter the power stand-by mode automatically
after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep
operation finishes.
1 While “SLEEP” is indicated, press the CLOCK/TIMER button.
2 Within 10 seconds, press the or button to select
“SLEEP X : XX”.
“X : XX” is remaining sleep time.
 The remaining sleep time is displayed for about 10 seconds.
 You can change the remaining sleep time while it is displayed by
pressing the MEMORY button. (Steps 4 - 5)
1 While “SLEEP” is indicated, press the CLOCK/TIMER button.
2 Within 10 seconds, press the or button to select
“SLEEP OFF”, and press the MEMORY button.
1 Set the sleep time (see left, steps 1 - 5).
2 While the sleep timer is set, set the timer playback or recording
(steps 2 - 10, pages 32 - 33).
Sleep timer setting
Timer playback or
recording setting
Sleep operation will
automatically stop
Timer playback or recording
start time
End time
1 minute - 3 hours Desired time