18
CD-XP250E(E)2.fm02/5/30
CD-XP250E
Radio
- Listening to the radio -
Listening to the radio (continued)
!
Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a
button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.
!
To recall a memorised station
!
To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)
!
To erase entire preset memory
1
Perform steps 1 - 3 in "Tuning" on page 17.
2
Press the MEMORY/SET button to enter the preset tuning saving
mode.
3
Within 30 seconds, press the PRESET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY/SET button to store that
station in memory.
If the "MEMORY" and preset number indicators go out before the station is mem-
orised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
When a new station is stored in memory, the station previously memorised will
be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to select
the desired station.
Preset channel Frequency and frequency band
This operation can be performed by pressing the TUNER PRESET ( or ) button
or or button on the remote control.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
"
The preset number will flash and the programmed stations will be tuned in se-
quentially, for 5 seconds each.
"
This operation can be performed by pressing the TUNER PRESET ( or )
button or or button on the remote control.
2 Press the PRESET ( or ) button again when the desired station is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the TUNER (BAND) button and the EQUALIZER/X-BASS/
DEMO button, press the ON/STAND-BY button until "TUNER CL" appears.
Tuning (See page 17.)
To Next Page
Loading...
