E-18
Timer and sleep operation (Remote
control only) (continued)
■ To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and
wake up to CD in the next morning.
1 Set the sleep time (see above, steps 1 - 5).
2 While the sleep timer is set, set the timer playback
(steps 2 - 10, page 17).
Sleep timer
setting
Timer playback
setting
End time
Timer playback
start time
Sleep operation will
automatically stop
Desired time10 - 90 minutes
Enhancing your system
The connection cord is not included. Purchase a
commercially available cord as shown below.
TIMER
REMOTE
SENSOR
Portable
audio
player, etc.
Audio cable (not supplied)
■ Listening to the playback sounds of
portable audio player, etc.
1 Connect a portable audio player etc. to the front
AUDIO IN jack.
2 Press the ON/STANDBY button to turn the power on.
3 Press the FUNCTION button repeatedly on the main
unit or AUDIO IN button on the remote control to select
AUDIO IN function.
4 Play the connected equipment.
If volume level of the connected device is too high,
sound distortion may occur. Should this happen, lower
the volume of the connected device.
If volume level is too low, increase the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■ Headphones
● Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and headphones
can cause hearing loss.
● Before plugging in or unplugging the headphones, reduce
the volume.
● Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
● Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner
without calling a service technician. If something is wrong
with this product, check the following before calling your
authorized SHARP dealer or service center.
■ General
Symptom Possible cause
● The clock is not set
to the correct time.
● A power failure occurred. Re-
set the clock. (Refer page 16)
● When a button is
pressed, the unit
does not respond.
● Set the unit to the power
standby mode and then turn
it back on.
● If the unit still malfunctions,
reset it. (Refer page 19)
● No sound is heard.
● The volume level set to “MIN”.
● The headphones are con-
nected.
● The speaker wires are not
connected.
■ CD player
Symptom Possible cause
● Playback does not
start.
● Playback stops in
the middle or is not
performed properly.
● The disc is loaded upside
down.
● The disc does not satisfy the
standards.
● The disc is distorted or
scratched.
● Playback sounds
are skipped, or
stopped in the
middle of a track.
● The unit is located near
excessive vibrations.
● Very dirty disc has been
used.
● Condensation has formed
inside the unit.
● “ER-CD21”
appears on the
display.
● The disc tray was stopped
with force. Set the unit to
the power standby mode
and then turn it back on.
■ Remote control
Symptom Possible cause
● The remote control
does not operate.
● The AC power cord of the
unit is not plugged in.
● The battery polarity is wrong.
● The batteries are dead.
● The distance or angle is
incorrect.
● The remote control sensor
receives strong light.
To Next Page
Loading...
Need help?
General
