E-8
RRMCGA409AWSA
TIMER
REMOTE
SENSOR
■ To turn the power on
The rst time the unit is plugged in, the unit will enter the
demonstration mode.
Function Main unit
Remote
control
Operation
Power on/
off
Press to turn the
power on or to
go to standby
mode.
Demo /
Bluetooth
Standby
____
Press to enter
demonstration
or Bluetooth
standby mode.
(During Power
off)
Eco mode
____
Press to enter
low power
consumption
mode. (During
Power off)
Note:
During demonstration or Bluetooth standby mode, NFC
function is activated once your device touches the NFC
detection area.
■ Display brightness control
To dim the display brightness, press the DIMMER button
on the remote control.
DIMMER 2
DIMMER OF
(Display is dim).
(Display is bright).
(Display gets dimmer).
■ Volume auto fade-in
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the
last set level.
■ Volume control
Turn the volume knob toward VOLUME +/– (on main
unit) or press VOL +/– (on remote control) to increase or
decrease the volume.
■ Muting
To mute the volume, press the button (remote control).
Press again to restore the volume.
■ X-BASS control (remote control)
When the power is rst turned on, the unit will enter the
extra bass mode which emphasizes the bass frequencies,
and “X-BASS” will appear. To cancel the extra bass mode,
press the X-BASS button.
■ Bass control (remote control)
1 Press the BASS button to select “BASS”.
2 Within 3 seconds, press the VOL (+ or -) button to
adjust the bass.
■ Treble control (remote control)
1 Press the TREBLE button to select “TREBLE”.
2 Within 3 seconds, press the VOL (+ or -) button to
adjust the treble.
■ Direct key power on function
When you press any of the following buttons, the unit turns
on.
● BLUETOOTH (PAIRING), CD, USB, AUDIO IN,
TUNER (BAND) button (remote control): Selected
function is activated.
● button (main unit or remote control): The unit
turns on and playback of the last function will start
(Bluetooth, CD, USB, AUDIO IN, TUNER).
●
(on main unit/remote control): Disc tray opens and
the last selected function is activated.
■ Auto power off function
The main unit will enter the standby mode after 15 minutes
of inactivity during:
AUDIO IN: No detection of input signal or very low sound
audibility.
CD / USB: In the stop mode.
Bluetooth: In the pause or stop mode and no incoming
signal from a source device.
■ Function
Press the FUNCTION button on the main unit repeatedly
to select desired function.
CD FM MONO AMFM STEREO
USBAUDIO INBLUETOOTH
Note:
The backup function will protect the memorized function
mode for a few hours should there be a power failure or
the AC power cord becomes disconnected.
General control
To Next Page
Loading...
Need help?
General
