Sharp DK-CL3P - Setting the Time and Date

2010 November 3
DK-CL3P_A6 01-21.fm
E-11
DK-CL3P
ENGLISH
Basic Operation
Setting the time and date
In this example, the clock is set for the 12-H (12 hour) display.
Note:
During battery operations in standby mode, press the SNOOZE/
DIMMER button to display the clock for about 5 seconds.
1 In standby mode, press the CLOCK button for more
than 2 seconds. The clock time display will blinking.
Press the or button to select clock time display
format and then press CLOCK button.
MEMORY
MEMORY
MON MON
2 Press the or button to adjust the hour and
then press the CLOCK button.
Press the or button once to advance the time by
1 hour. Hold it down to advance continuously.
“AM” or “PM” indicator will interchange after each 12 hour
cyclic in 12-H clock format.
3 Press the or button to adjust the minutes and
then press the CLOCK button.
Press the or button once to advance the time by
1 minute. Hold it down for about 2 seconds to change the
time in 5-minutes interval.
4 Press the or button to adjust the day and then
press the CLOCK button.
“:” will be blinking to indicate time and date setting is
completed.
MON
MON
MON
THU