E-18
2010 November 3
DK-CL3P_A6 01-21.fm
DK-CL3P
1
ENGLISH
Advanced Features/Reference
■ Listening to the audio/video sounds from
portable audio player, computer etc.
Note:
To prevent noise interference, place the unit away from the
television and do not make any auxilary playback while listening
to the iPod or iPhone.
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following
before calling your authorized SHARP dealer or service center.
■ General
■ Tuner
1 Use the auxiliary cable to connect the portable audio
player, computer etc. to the AUDIO IN jack.
When using video equipment, connect the audio output to
this unit and the video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the FUNCTION button to select AUX function.
4 Play the connected equipment.
Symptom Possible cause
● The clock is not set to the
correct time.
● Did a power failure occur?
Reset the clock. (Refer to
page 11)
● When a button is
pressed, the unit does
not respond.
● Set the unit to the power
stand-by mode and then turn
it back on.
● If the unit still malfunctions,
reset it.
(Refer to page 19)
● No sound is heard. ● Is the volume level set to “0”?
Symptom Possible cause
● The radio makes unusual
noises continuously.
● Is the unit placed near the
TV or computer?
● Is the FM antenna placed
properly? Move the antenna
away from the AC/DC
adaptor if it is located
nearby.
To Next Page
Loading...
