Sharp DR-430 User Manual

10
The current setting will have an asterisk (*) in the
display. Press
to select.
Similarly, use
to change the settings
for the backlight brightness for the <Dim level>
and <On level>. There are 3 options available:
<High>, <Medium>, and <Low>.
Display language
To change the display language, long press
. Use
to scroll and select <System> /
<Language>. Use
to scroll and select
your preferred language. There are 7 options
available: English, French, German, Italian,
Spanish, Polish, and Dutch. An asterisk (*) will be
displayed next to the current language setting.
Other information
Software version
To check the software version of your radio, long
press
. Use to scroll and select
<System> / <SW Version>. The software version
will be displayed.
Factory reset
You can reset your radio to restore it to the
original factory settings.
Note: If you reset your radio, your stored presets
will be deleted and any connected Bluetooth
device will be unpaired.
Long press
. Use to scroll and select
<System> / <Factory reset>. <Factory Reset?
<No> Yes> will be displayed. Use
to
scroll and select <Yes>. <Restarting…> will be
displayed. After a few seconds, the display will
change to <SHARP sharpconsumer.eu> and will
then go to standby mode.
Troubleshooting
If there is no sound or power:
• Adjust the volume.
• Check that the power cable is connected and
that the radio is not in standby mode.
If the radio reception is poor:
• Make sure that you have fully extended the
telescopic aerial (preferably vertically).
• Rescan for radio stations, see sections ‘Scanning
for DAB stations’ and/or ‘Tune to an FM station’
as appropriate.
• Try moving your radio to another location to
see if the reception improves.
• Check that you do not have other electrical
equipment close to your radio. This may cause
interference.
If you are unable to pair with a Bluetooth
device:
• Check that you are in Bluetooth mode.
• Ensure that you are within 10 metres of the
radio for Bluetooth functionality.
• Move the radio and Bluetooth device away from
other Bluetooth devices/electrical equipment.
• If possible, turn o other nearby Bluetooth
devices or disable their Bluetooth functionality.
If the function buttons do not respond:
• Short press
.
• Switch o the power supply to the unit, wait 10
seconds and reconnect power supply.
Note: All your settings, including the radio station
list, connected Bluetooth devices and any presets
will be deleted when a factory reset is carried out.

Sharp DR-430 Specifications

General

Brand	Sharp
Model	DR-430
Category	Radio
Language	English