Sharp DV-NC55U

10
DV-NC55U/C/M
6. DISASSEMBLY METHOD
6-1. DISASSEMBLY METHOD
1) Removing the cabinet.
(1) Remove the five screws 1 and 2.
2) Removing the front panel.
(1) Remove the earth plate.
(2) Remove the three screws 3.
(3) Remove the three hooks 4.
3) Removing the front PWB.
(1) Remove the shild plate.
(2) Remove the four FFCs 5 and 6.
(3) Release the two hooks 7 and tilt the PWB toward you to
remove it.
(4) Release the two hooks 8 and tilt the PWB toward you to
remove it.
4) Removing the DVD mechanism.
(1) Remove the six screws 9.
(2) Remove the DVD REINF. angle 0.
(3) Remove the connector q.
(4) Remove the two FFCs w.
2
1
1
3
7
6
4
5
6
8
Shild Plate
9
9
10
12
12
11
12
22
21
20
15
16
14
17
16
18
19
23
24
(5) Peel the FFC w off the DVD mechanism.
(6) Remove the FFC r.
(7) Remove the shield (lower) t.
(8) Remove the two FFCs y, and at two connectors u, and
at four screws i.
(9) Remove the wire from the wire holder o.
(10)Remove the DVD main PWB p.
(11)Remove the FFC cover a.
(12)Remove the two interface PWB holders s, and remove
the interface PWB d.
(13)Remove the two screws f.