11 | P a g e
Time:
• Enter in the order of hour, minutes, then press to
complete the entry.
(There is no entry available for the seconds’ value. The
clock starts at zero second.)
• If the hour/minute digit is less than 10, it is not
necessary to enter the first digit “0”.
• Use to separate hour and minute values.
• When is pressed, the number entered is
evaluated and displayed as “time” if the value is within
the following range; “Error” is displayed otherwise, and
the previously set time is restored.
Hour: 0 - 23 (24-hour system for the hour entry),
Minute: 0 – 59
Conversion rate:
• Press twice, enter the conversion rate, followed by
.
• A maximum of 6 digits can be stored (decimal point is
not counted as a digit).
Tax / discount rate:
• Press twice, enter the tax rate, followed by .
• Press twice, enter the discount rate, followed by
then .
• A maximum of 4 digits can be stored (decimal point is
not counted as a digit).
Note:
• Be sure to set this selector to the “” position after
storing an each rate.
• For the conversion rate and the tax / discount rate, a
single value can be stored for each. If you enter a new
rate, the previous rate will be cleared.
To Next Page
Loading...
