8
THE FUNCTIONS OF THE CONTROL PANEL
• Press this button to turn the power 'ON' or 'OFF'.
• Operation and temporary stop is repeated as it is pressed.
• When you want to change course in operating;
press the 'Start/Pause' button → Select the course that you want to change
→ press the 'Start/Pause' button again.
• It can be used to select the full-automatic course.
• By turning(right) the 'Program' Dial, course will be selected by following
order :
Auto/Fuzzy → Baby Care → Quick → Tub clean → Blanket → Wool → ...
• This selection is effective for blue-jean, etc ...
• Washing time, rinse times and spin time are selected automatically depend
on amount of laundry.
• Select the desired amount of water depending on the amount of laundry.
• As the button is pressed, water level is selected by
MEDIUM → HIGH → EXTRA LOW → LOW → MEDIUM → ...
• It can be used to adjust washing time.
• As the button is pressed, washing time will be repeated.
18 → OFF(0) → 6 → 10 → 15 → 18 → ...
• Use it to change the number of rinses.
• As the button is pressed, the times of rinse will be repeated.
3 times → 4 times → OFF(0) → 1 time → 2 times → 3 times → ....
• It can be used to change spin time.
• As the button is pressed, spin time will be repeated.
5 → 7 → 9 → OFF(0) → 1 → 3 → 5 → 7 → ...
• Use it to set time reservation.
• If the 'Res.' button is pressed, '2' is displayed.
You can reserve it from 2 to 48 hours in advance.
• Each pressing of the button advances on time delay by one hour.
2 → 3 → 4 → … → 46 → 47 → 48 → 2 → 3 → 4 → …
• It can be used to adjust the wind-drying time after spin.
• As the button is pressed, the wind-drying time will be repeated as following;
10 → 20 → 30 → 40 → 0
To Next Page
Loading...
Need help?
General