How to improve washing result in Sharp ES-NFB814BSNA-EN Washer with hard water?
If you're getting unsatisfactory washing results with your Sharp Washer, and you have hard water, increase the amount of detergent following the manufacturer’s instructions. Also, check that your laundry is spread out.
Why Sharp ES-NFB814BSNA-EN won't start?
If your Sharp Washer won't start, several factors could be the cause. First, ensure the machine is properly plugged into a working power outlet. Check the fuses and replace them if they are faulty. Also, verify that there is mains power supply. Make sure you have pressed the Start/Pause button and that the program dial is not in the 'stop' position, turn the programme dial to the desired position. Finally, ensure that the machine door is completely closed.
Why is the spin cycle delayed on my Sharp Washer?
If the spin cycle on your Sharp Washer is delayed or doesn't occur, it might be because the Unbalanced load control system has been activated. This is not a fault. The system is attempting to redistribute your laundry. Once the load is balanced, the spin cycle will commence. For future washes, load the drum evenly.
Why is my Sharp ES-NFB814BSNA-EN Washer not taking in water?
If your Sharp Washer isn't taking in water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist if necessary. Also, the water inlet hose or inlet filter may be clogged, so clean these filters. Lastly, ensure that the machine door is completely closed.
How to stop my Sharp ES-NFB814BSNA-EN from vibrating?
If your Sharp Washer vibrates excessively, it might be due to several reasons. Check if the feet of the machine have been properly adjusted. Ensure that the transit bolts, used for transportation, have been removed. Avoid placing the machine on a hard surface. If you've overloaded the machine or the laundry is unevenly spread, redistribute the load evenly. Note that a small load can also cause vibration, but this will not prevent the operation of your machine.
Why spin cycle of Sharp Washer is delayed?
If the spin cycle in your Sharp Washer isn't happening or is delayed, it might be because the Unbalanced load control system has been activated. This system will try to spread your laundry, and the spinning cycle will begin once your laundry is spread. For the next wash, load the drum evenly.
Why Sharp ES-NFB814BSNA-EN Washer gives unsatisfactory washing result?
If you're experiencing unsatisfactory washing results with your Sharp Washer, it could be because your washing is too dirty for the selected program; use the information in the program tables to select the most appropriate program. Ensure you are using enough detergent as instructed on the packaging. Also, check that you have not exceeded the maximum capacity for the selected program.
Why is my Sharp ES-NFB814BSNA-EN vibrating so much?
If your Sharp Washer is vibrating, make sure the feet have been adjusted properly. Check that the transit bolts, which are fitted for transportation, have been removed from the machine. If you have a small load in the drum, this will not prevent operation of your machine. Avoid overloading the drum and spread laundry evenly. Also, do not set up your Washing Machine on a hard surface.
What to do if Sharp ES-NFB814BSNA-EN Washer does not intake water?
If your Sharp Washer isn't taking in water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist it if necessary. Also, the water inlet hose or inlet filter may be clogged, so clean the water inlet hose filters and the inlet filters. Lastly, ensure that the machine door is completely closed.
What to do if my Sharp Washer does not discharge water?
If your Sharp Washer isn't draining water, the drain hose might be clogged or twisted; inspect it, and either clean or untwist it. Another potential issue is a clogged pump filter, which should be cleaned. Also, if the laundry is too tightly packed in the drum, redistribute it evenly.
General| Capacity | 8 kg |
|---|---|
| Spin Speed | 1400 rpm |
| Energy Efficiency Class | B |
| Color | White |
| Water Consumption | 48 L/cycle |
To Next Page