Sharp FU-888SV - OPERATION - MAIN UNIT; Main Unit Controls & Modes

OPERATION
MAIN UNIT OPERATION
MODE/OFF button
The unit will start operation when the MODE/OFF button is pressed.
(The unit will start operation in AUTO mode)
• During operation, the cluster ion lamp will light up.
(Cluster ion mode is set to be AUTO in the initial operation)
Various operation modes suitable for different conditions are available.
Stop
AUTO operation
The fan speed is automatically switched (High, Medium, Low) depend-
ing on the air quality detected by the dust sensor.
Low operation
The unit will operate silently with little discharged air.
Medium ~ Maximum operation
The unit will operate with at medium, high or maximum fan speed.
*
Tobacco smoke removal operation
The unit will operate in High fan speed for 10 minutes, then the unit will
return to AUTO mode.
10 minutes: High fan speed
AUTO mode operation
Pollen removal operation
The unit will operate in High fan speed for 10 minutes, then the unit will
alternately operate between Low and High fan speed.
10 minutes: High fan speed
20 minutes: medium fan speed
20 minutes: High fan speed
For the first 30 seconds after the power plug is inserted
into the wall outlet, the unit will check the conditions of
the air. If operation is set to ON during this time, the
Clean sign lamp will alternately flash in green, orange
and red. During this time, the Cluster ion lamp will light
blue and the unit will be in the Clean mode.
Cluster ion lamp
• AUTO operation
• Low operation
• Medium operation
• High operation
• Maximum operation
•
*
Tobacco smoke removal
operation
• Pollen removal operation
Operations available with
main unit
E-10
Plasmacluster
*
It can’t remove the noxious
substances (carbon monox-
ide etc.) of cigarette.