Sharp FU-888SV - PREPARATION - FILTERS & BATTERIES; Installing Air Filters; Remote Battery Setup & Care

PREPARATION
Be sure to remove the power plug from the wall outlet.
INSTALLING THE FILTERS
To maintain the quality of the filters, they are pre-installed in the main unit and covered with
plastic bags. Be sure to remove the filters from the plastic bags before using the unit.
1 Remove the filters
1
Place the unit with its front
side facing up
Place the unit on a flat surface, and make
sure that the stand does not contact the
surface.
2
Remove the front panel
Press the hook on the bottom of the front
panel and lift up to remove.
3
Take out the pre-filter, and
then take out the stamina-
power carbon (black) and
HEPA filter (white) from the
plastic bags.
INSERTING BATTERIES INTO THE REMOTE CONTROL
1
Remove the
back cover
Press the cover and
slide towards your-
self.
2
Insert batteries
Insert batteries ac-
cording to the
and as shown be-
low.
3
Close the back
cover
About the batteries
• Life of the batteries is about 1 year.
Replace the batteries when the remote
control does not function.
• Improper use of the batteries may cause
battery fluid leakage and/or damage. Be
sure to follow the instruction below:
• When replacing the batteries, replace
both batteries with new ones of the
same type. (Use AA size alkaline bat-
teries (2 pieces) or AA manganese bat-
teries (2 pieces).)
• Remove the batteries when not in use
for long period to avoid malfunction
caused by fluid leakage.
* The included batteries are for initial use
only and may deplete within 1 year.
Soft cloth
Prefilter
Table, etc.
Front panel
1
1
2
2
1
The stand should
not be contorted
with the surface
Hook
Stamina-power carbon
E-8