E-10
Take out the earbuds from the charging
case. They will automatically power on
and auto reconnect via Bluetooth to the
last device paired.
Notes:
● When the left (L) or right (R) earbuds
are taken out for the rst time, it will
enter pairing mode. Turn on your
bluetooth device and search for “HP-
TW10 SHARP”
● If the earbuds are not turned on,
touch and hold both L and R MFB
pad for about 2 seconds.
To power off:
● Place the earbuds back into the
charging case. It will turn off
automatically and disconnect the
Bluetooth connection.
● Touch and hold L or R MFB pad for
more than 5 seconds.
The earbuds will automatically power
off if there is no bluetooth connection
between the bluetooth source device
and the earbuds for more than 5
minutes.
General control
Power on Power o
To Next Page
Loading...
