E-11
shall not be exposed to excessive heat such
as sunshine, re or the like.
Installing the battery incorrectly may cause
the unit to malfunction.
Notes concerning use:
Replace the battery if the operating distance
is reduced or if the operation becomes
erratic. Purchase “CR 2025”, coin lithium
battery.
Periodically clean the transmitter on the
remote control and the sensor on the unit
with a soft cloth.
Exposing the sensor on the unit to strong
light may interfere with operation. Change
the lighting or the direction of the unit if this
occurs.
Keep the remote control away from moisture,
heat, shock, and vibrations.
●
●
●
●
●
Remote control
(continued)
General control
To turn the power on■
Press the ON/STAND-BY button.
The sound mode indicator and display light up.
Note:
If the power does not turn on, check whether the
power cord is plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
●
Display brightness control■
Press the DIMMER button to adjust the brightness
of the display and sound mode indicator.
Sound mode indicator and display bright
Sound mode indicator and display dim
Sound mode indicator and display off. Pressing
any button will light up the display for 3
seconds only.
Volume auto fade-in■
If you turn off and on the unit with the volume set
to 40 or higher, the volume starts at 20 and fades
in to the last set level.
Volume control■
Unit operation:
Press volume up (VOL. + ) to increase the volume
and press volume down (VOL. – ) to decrease the
volume.
To Next Page
Loading...
Need help?
General
