Even if the Remote Control is operated within the effective range of 6m, remote control operation may be
affected if there are obstacles between the unit and the remote control.
If the Remote Control is operated near other products which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other products
may operate incorrectly.
BATTERY INSTALLATION
1. Press and slide the back cover to open the battery compartment of the remote control.
2. Insert two AAA size batteries (included). Make sure the (+) and (-) ends of the batteries match the (+) and ()
ends indicated in the battery compartment.
3. Close the battery compartment cover.
First time installation
Placement and Mounting
A: Normal Placement (Place Sound bar on leveled surface in front of TV.)
B: Wall Mounting
Wall Mounting
NOTE:
— Installation must be carried out by qualified personnel only. Incorrect assembly can result in severe personal injury
and property damage (if you intend to install this product yourself, you must check for installations such as electrical
wiring and plumbing that may be buried inside the wall). It is the installer’s responsibility to verify that the wall will
safely support the total load of the unit and wall brackets.
— Additional tools (not included) are required for the installation.
— Do not overtighten screws.
— Keep this instruction manual for future reference.
— Use an electronic stud finder to check the wall type before drilling and mounting.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
