NOTE:
— If the wireless connection fails again, check if there is conflict or strong interference (for example, interference
from an electronic device) around your location. Remove these conflicts or strong interferences and repeat the above
procedures.
— The subwoofer should be within 6m of the sound bar in an open area.
— If a device is connected via HDMI (CEC active), the main unit and the subwoofer will switch on automatically when
the external device is switched on.
Basic Operation
Standby/ON
When you first connect the unit to the main socket, the unit will be in STANDBY mode.
Press the button on the remote control to switch the main unit ON or OFF.
Disconnect the plug from the mains socket if you want to switch the unit off completely.
— When the unit has no input signal for over 15 minutes, it will automatically switch to Standby mode.
Select Modes
Press the button on the unit repeatedly or press the button on the remote control to select the desired mode.
Adjust the Volume
— Press the + / – buttons on the unit or on the remote control to adjust the volume.
— If you wish to turn the sound off, press the button on the remote control. Press the button again or press the
+/- buttons on the unit or on the remote control to resume normal listening.
Select Equalizer (EQ) Effect
While playing, press the EQ button on the remote control to select between preset equalizers. Each time the button is
pressed it will move between the EQ functions as below:
Music (recommended for listening to all types of music) – white light flashes 2 seconds Movie (recommended for use
with movies) – green light flashes for 2 seconds News (recommended for listening to voices) – red light flashes for 2
seconds Custom (use to set personal bass/treble settings) – cyan light flashes 2 seconds
NOTE: Bass/Treble setting is available only in custom preset.
LINE IN/OPTICAL/HDMI ARC
1. Ensure that the unit is connected to the TV or audio device.
2. While in ON mode, press the button on the unit repeatedly to select the desired mode.
3. Operate your audio device directly for playback features.
4. Press the +/ button to adjust the volume to your desired level.
TIP:
While in HDMI ARC/OPTICAL mode, if there’s no sound output from the unit, you may need to activate PCM
signal output on your source device (eg. TV, DVD or Blu-ray player).
Bluetooth Operation
Pair Bluetooth-enabled Devices
The first time you connect your Bluetooth device to this player, you need to pair your device to this player.
NOTE:
—The operational range between this player and a Bluetooth device is approximately 8 meters (without any object
between the Bluetooth device and the unit).
— Before you connect a Bluetooth device to this unit, ensure you know the device’s capabilities.
— Compatibility with all Bluetooth devices is not guaranteed.
—Any obstacle between this unit and a Bluetooth device can reduce the operational range.
— If the signal strength is weak, your Bluetooth receiver may disconnect, but it will re-enter pairing mode
automatically.
1. Turn on the sound bar by pressing the standby button.
2. Press the button on the unit repeatedly or button on the remote control to select Bluetooth mode. Bluetooth
To Next Page
Loading...
Need help?
General
Weight and Dimensions
