EN-16
The Unit Replacing Lamp flashes rapidly and the
operation is stopped.
• The product is past its usage period. Replace it with a new
Plasmacluster Ion Generating Unit. (Page 9,14)
All Operation Lamps flash at the same time and the
product stops.
• The Plasmacluster Ions are not generated. Perform maintenance
of the electrode section. (Page 13)
• Is the Plasmacluster Ion Generating Unit installed correctly? Pull
out the unit and insert it again and then press the Operation
Button. (Page 10,11)
• If the Lamps flash repeatedly, contact the store of purchase or
SHARP authorized service center.
A discontinuous noise is heard.
A clicking or ticking sound comes from the product.
• Clicking or ticking sound may be audible when the product is
generating ions. You may feel the sound becomes louder or
softer depending on use environment or operation mode,
however, the effect of Plasmacluster Ion is not changed.
• Dust may block the filter. Clean the filter. (Page 12)
The Operation Lamp flash and the product stops.
• Please remove the Car Adapter and reinsert it, then press the
Operation Button again.
• If this happens repeatedly, contact the store of purchase or
SHARP authorized service center.
Other indication
• Failure
Unplug and contact the store of purchase or SHARP authorized
service center.
OM_IG-NX2_EN_MS_VT_CS.indb EN-16OM_IG-NX2_EN_MS_VT_CS.indb EN-16 31/5/2564 BE 16:5031/5/2564 BE 16:50
To Next Page
Loading...
Need help?
General
