Sharp IQ-9200

[Tablet mask unit]
Handling of the tablet
¢ Do not put stress on the pressure fit area when handling the
tablet.
* Do not bend the pressure fit area in an acute angle.
* Do not touch the pressure fit area with your fingertip.
ZY 2
_ side :
, aos
Contact area
Terminate
Tablet
[Display bottom cabinet unit]
@ Attaching the reinforcing plate
* Note the bonding direction.
* Apply it to the stage on the right side corner when installing.
ZZ
@ Attaching the LCD cushion
* Apply it to the stage on the right side corner when installing.
* Do not allow it to override the stage.
OK NG
"VILA.~—~CO*é‘“C~*‘ RS
@ Shield tape attachment (IQ only)
* Be sure to eliminate floating and wrinkle when attaching.
Lower reference
Press and attach carefully
OZ-9600IT
IQ~9200
i sé]
Shield tape
@ FPC (FG pattern) and LCD angle soldering
® O2Z-9600M2
FG pattern
Soldering
(Solder the
paw! section
of the LCD
angle and the
FG pattern
of FPC.)
LCD unit
® 1Q-9000/9200 series
[For models using a new PWB: QPWBX1031PCZZ]
FG pattern
LCD unit Soldering
(Solder the
LCD angle
A pawl and
the FG pattern
of FPC.).
LCD angle paw!
Copper foil
*Not required when an old PWB is used.
Note:
° Check that the LCD angle pawl is bent to a flat position, then
solder. Adjust the quantity of solder so that its height is within .
imm.
Angle Angle
Max.imm | zZ
FPC
(O) (X)
© The max. applying time of soldering iron is 3 sec. Do not press the
pawl with the soldering iron.
7 aa
FPC
ae