Sharp IQ-9200

® Bonding the PET holding tape
* Bond it straight so that the PET-B may be hidden.
* Must be bonded within the range of the PET-B hole size.
Equa! on center
Cemented side
@ Installing the hinge, large, B
¢ Note the installing direction.
* Four tabs must be inserted firmly into the hinge, large.
@ Installing the display bottom plate to the cabinet
* Tabs at eight locations must be firmly engaged to the cabinet.
[Key bottom cabinet unit]
@ Bonding the reinforcing angle holding tape
* Align to the holes before bonding (rib to the shadowed area).
° Never allow it to have separation and creases.
* Do not override the rib.
Q Q CLZZZD)
® Installing the reinforcing angle
* Align to the holes before bonding {rib to the shadowed area).
@ Attaching the static sheet
° Align the area (A) to the stage on the cabinet.
* Must be attached without separation and creases.
* Press the corner at the area (B) using a blade to firmly bond it. (Do
not scratch it.)
; —— Corner
OK |: : | ie
i Corner
AreaB
ae
OZ-9600IT
IQ-9200
@ Key cabinet A insulation sheet C attachment
* Fit sections C to dent portions of the cabinet.
* Attach securely without floating and wrinkles..
Section C
@ Attaching the infrared mirror holding angle
* Do not allow it to override the rib.
ae Reference line
es es a Reference line
Reference line
@ Handling the infrared filter
* The reverse side of the infrared filter must be clean from finger
print and other contamination.
@ Attaching the backup battery label
* Note the installing direction.
® Do not allow it to override the cabinet.
BE SURE
THE OPERATING
BATTERIES ARE
FRESH AND
INSTALLED WHEN
REPLACING THIS
BATTERY.
O Me @.
Lipo
@ Attaching the display cabinet blind sheet
* Do not allow it to have separation and override to the stage.
ee
Oo
@ Attaching the battery holding insulation sheet
* Do not allow it to have separation and creases when attaching.
"© The figure below shows the reading direction.
Equal on center
:_ Equal on
center —
-35-