Sharp KSH-106 - Adjustment of Switch Lever and Contacts

6
To repair rice cooker, the following parts should be carefully checked and / or repaired in the proper manners.
1. Inner Pot
Outer Side : It must be cleaned without any contaminants and particles at the bottom for it can be firmly
contacted the heater plate evenly.
Inner Side : It must be cleaned without dry cooked rice at the bottom, otherwise it can be the prevention of
heat transmission throughout the inner pot. And it may cause temperature at the bottom raise
up to the level which can be switched of the heater plate (as above explained) before the proper
time. So, it may cause improper rice-cooking.
2.. Heater Plate and Thermostat
- Ensure that there is no any contaminant or deposits on heater plate and thermostat, it will cause the operation
of switching off before the proper time.
3. Switch Lever and Micro switch
- The lever and micro switch must be in proper alignment.
4. Switch Ass’y
- Switch ass’y must be in proper working, otherwise it may cause thermostat be unable to cut off when rice is
already cooked.
A. Thermostat rod must not be drew up by switch lever. It should be moving left and right easily.
Push the Switch Cook
Switch Cook
Gap
Gap
Gap
A
ADJUSTMENT OF SWITCH LEVER AND CONTACTS
Bottom Lid
Outer Pot
Switch Cook
Inner Pot
1. Turn over the outer pot with inner pot inside, disclose its bottom lid. Push switch cook, adjust switch lever
and switch angle.