Appendix
Problem Possible Solution
Playback doesn’t start.•
No disc is inserted. (See page 23.)•
The disc may be dirty. Clean up the disc. (See page 21.)•
The TV/DVD cannot play CD-ROMs, etc. (See page 21.)•
No picture.• TV/DVD selector is not set correctly. (See page 23.)•
No sound.• Check the input selector of the amplifier is set properly.•
The TV/DVD is in the special playback mode. (See pages 23, 24.)•
Select the correct Audio Output position on AV amplifier.•
Picture is distorted during fast •
reverse/forward playback.
The picture will be distorted occasionally.•
Stopping playback, search, slow •
motion play, repeat play, or program
play, etc. cannot be performed.
Some discs may not do some of the functions.•
No surround sound.• The setup does not match your stereo system.•
The TV/DVD or remote operation •
key is not functioning.
Turn off the TV/DVD and unplug the AC power cord for several minutes, •
then replug it.
Playback does not start when the •
title is selected.
Check the Parental setup. (See page 30.)•
Audio soundtrack and/or subtitle •
language is not changed when you
playback a DVD.
Multilingual language is not recorded on the DVD disc. (See page 24.)•
No subtitle.• Some discs have no subtitles. (See page 24.)•
Subtitles are cleared. Press •
. (See page 24.)
Angle cannot be changed.• Multi-angles are not recorded on the DVD disc. (See page 25.)•
“This operation can’t be performed” •
appears on the screen.
The function is prohibited with the TV/DVD or the disc. (See page 24.)•
Cautions regarding use in high and low temperature environments
When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear •
slightly delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct •
sunlight or near a heater, as this may cause the cabinet to deform and the LCD panel to malfunction.
Storage temperature: –20°C to +60°C.
Devices connected to the protective earthing of the building installation through the MAINS connection or
through other devices with a connection to protective earthing and to a television distribution system using
coaxial cable, may in some circumstances create a fire hazard. Connection to a television distribution system
therefore has to be provided through a device providing electrical isolation within a certain frequency range
(galvanic isolator, see EN 60728-11).
NOTE
For requirements in Norway and Sweden, the requirements for isolation are also relevant for devices that can •
be connected to television distribution systems.
Troubleshooting-DVD
37
54B0101A_English.indd 3754B0101A_English.indd 37 3/2/2010 11:01:123/2/2010 11:01:12
To Next Page
Loading...
Need help?
General
