LC-24LE170I
10 – 1
CHAPTER 10. SCHEMATIC DIAGRAM
[1] DESCRIPTION OF SCHEMATIC DIAGRAM
1. VOLTAGE MEA
SUREMENT CONDITION:
1) The volt ages at test points are measured on exclusive AC adaptor and the stable supply voltage of A C 11 0-240V . Signals are fed byacolour bar signal
generator for servicing pur
pose and the above volt ages are measured witha20k ohm/V tester .
2. INDICATION OF RESISTOR & C
APACITOR:
RESIST
OR
1) T he unit of resist ance " " is omitted.
(K=k =10 00 , M=M ).
2) All resistors a re±5%, un less otherwise noted.
(K= ± 10 %, F= ± 1% , D=±0.5%)
3) All resistors are 1/16W , unless otherwise noted.
C APACITOR
1) All capacitors are F, unless otherwise noted.
(P=pF =
F)
.
2) All ca pacitors are 50V, unless otherwise noted.
CAUTION:
T
his circuit diagram is original one ,
therefore there may be
a sl ight
difference from yours.
SAFETY
NOTES:
1) DISCONNECT THE AC PLUG FROM THE AC OUTLET
BEFORE REPLACING P
ART S.
2) SEMICONDUC TOR HEA T
SINKS SHO
U
LD BE REG
ARDED AS
POTENTIAL SHOCK HAZARDS WHEN THE CHAS
SIS IS
OPERA
TING .
IMPORTANT SA
FETY NOTICE:
P
AR T S MARKED WITH " "
( )
ARE IMPOR
TANT
FO R MAINTAINING
THE SAFETY OF THE S ET . BE SURE TO
REPLACE THESE PA
RTS WITH SPECIFIED ONES FOR MAIN-
TA INING TH E SAFET Y AND PERFO RMANCE O F T HE S ET.
To Next Page
Loading...
