LC-32LE350M
6 – 3
2. SIGNAL ADJUSTMENT
A. PICTURE ADJUSTMENT
Confirmation of signal from generator (setting to spec level)
PAL Composite signal ˖0.7Vp-p ± 0.02Vp-p (pedestal to white level)
15K Component signal (50Hz) ˖Ylevel ˖0.7Vp-p ± 0.02Vp-p (pedestal to white level)
Pb, Pr level ˖0.7Vp-p ˖0.7Vp-p ± 0.02Vp-p
33K Component signal ˖Ylevel ˖0.7Vp-p ± 0.02Vp-p (pedestal to white level)
Pb, Pr level ˖0.7Vp-p ˖0.7Vp-p ± 0.02Vp-Com
a) Adjustment Mode
NO. ERUDECORPNOITIDNOCM
ETI
1 Adjustment Mode Press the test key at the test remote control
b) Component 15K 50Hz Signal Adjustment (COMP-SD)
NO. ERUDECORPNOITIDNOCMETI
1 Setting [Signal]
COMP 15K 50Hz
(576i)
100% Full-field
Colour Bar
[Terminal]
COMPONENT
INPUT 3
ί
Feed the COMPONENT 15K 50Hz (576i) 100% Full-field
Colour Bar signal(100% colour saturation) to
COMPONENT INPUT 3
2 Auto Adjustment Test Mode page 4
(COMP SD)
At the related page, move cursor to [COMP SD ADJ], press
ENTER.
[OK] appears when finished.
100% White
ėĕ
Black
c) Component 33K 60Hz Signal Adjustment (COMP-HD)
NO. ERUDECORPNOITIDNOCMETI
1 Setting [Signal]
COMP 33K 60Hz
(1080i)
100% Full-field
Colour Bar
[Terminal]
COMPONENT
INPUT 3
ί
Feed the COMPONENT 33K 60Hz (1080i) 100% Full-field
Colour Bar signal(100% colour saturation) to
COMPONENT INPUT 3
2 Auto Adjustment Test Mode page 5
(COMP HD)
At the related page, move cursor to [COMP HD ADJ], press
ENTER.
[OK] appears when finished.
d) PC (ANALOG RGB) Signal Adjustment (PC-RGB)
NO. ERUDECORPNOITIDNOCMETI
1 Setting [Signal]
XGA 60Hz
100% Checkered
Pattern
[Terminal]
PC INPUT 4
ί
Feed the XGA 60Hz 100% Checkered pattern signal
(100% colour saturation) to PC INPUT
䯲
Please make sure SYNC is OFF.
2 Auto Adjustment Test Mode page 6
(PC-RGB)
At the related page, move cursor to [RGB ADJ], press
ENTER.
[OK] appears when finished.
100% WhiteėĕBlack
To Next Page
Loading...
