Sharp LC-32WD1E/S/RU - Page 42

NO picture on display via EXT-3 CVBS input
No picture on LCD screen when EXT-3 CVBS input source selected
Checklist:
1) Is "INPUT SOURCE" button on the remote control set up correctly ? ==> See operation manual and set "INPUT SOURCE" to "EXT3"
2) Is MENU-PICTURE-Contrast/Brightness set to "MIN" ? ==> Set it to appropriate level
3) Check connection to external device ==> Connect it correctly as per the operation manual for the device
v yes
Is composite video signal arriving to pin1 of connector X014 on Side
I/O PCB ?

no
Check external connection, input setting, connector X011-2 and
peripheral circuits (termination R, ESD protection diode,…)
v yes
Is CVBS signal present on pin1 of X0208 on Main PCB ?

no
Check connectors X014 on side I/O PCB and X0208 on
Main PCB, check wiring between these connectors.
v yes
Is CVBS signal present on both sides of C01100 ?

no
check C01100, check peripheral on FRONT_Y_CVBS_IN signal
(termination R, BLM,…)
v yes
Is TDA15134E (D013) UOCV_DVCLK clock there
AND are the UOCV_DV(x) signals toggling?

no
TDA15134E (UOCV) (D013) is not functioning normal,
check GTV SW and peripherals (power supply,xtal,…) of D013
v yes
are UOCV_DV(x) and UOCV_DVCLK signals arriving to
the CPLD (D080) (XC2C128-7TQG144C) ?

no
check resistor networks on UOCV_DV signals
v yes
GOTO VIDEO PATH CHECK
LC-32WD1E/S/RU, LC-37WD1E/S/RU, LC-42WD1E/S/RU, and LC-32/37/42WT1E
6-11