26
Basic adjustment settings
No signal off
When set to “Enable”, the power will automatically shut
down if no signal inputs for 15 minutes.
Press a/b to select “No Signal Off”, and
then press ENTER.
Press c/d to select “Enable”, and then
press ENTER.
3
4
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
• When a TV program finishes, this function may not operate.
Press c/d to select “Power Control”.
Press MENU and the MENU screen displays.
No operation off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
Press a/b to select “No Operation Off”, and
then press ENTER.
Press c/d to select “Enable”, and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
Repeat steps 1 and 2 in No signal off.
2
1
DisableEnable
3
2
1
Power Control
Power control setting allows you to save energy.
Digital Setup
This setting allows you to optimize the settings of Digital
broadcasting.
Audio Setup
You can output digital audio to an AV amplifier or similar
device whose DIGITAL AUDIO INPUT terminal is
connected to the DIGITAL AUDIO OUTPUT terminal
on the TV. Please select an audio output format
compatible with the audio format of the program you
are watching and the equipment connected.
1
2
3
Press MENU and the MENU screen displays.
Press c/d to select “Digital Setup”.
Press a/b to select “Audio Setup”, and then
press ENTER.
4
Press a/b to select “PCM” or “Dolby
Digital”, and then press ENTER.
Selected item
PCM
Dolby Digital
Description
• The optical output terminal outputs audio
signal by PCM form. If your digital audio
system does not support Dolby Digital,
select “PCM”.
• The optical output terminal outputs audio
signal by Dolby Digital form. It reproduces
sound from surround program of digital.
LC-37DB5U(E)-23-26 05.8.1, 1:10 PM26
To Next Page
Loading...
Need help?
General