-11-
1. Connect one end of the RF coaxial cable (not
included) to the aerial socket on the wall and the
other end of the cable to the RF (75Ω) socket at
the rear right bottom view of your television.
2. Connect the main cable to the main socket after
you have completed all the connections.
3. In standby mode, press the POWER button on
the front right side panel of the television or the
button on the remote control to turn the television
on. The red LED indicator will turn blue.
4. The rst time you turn the television on, it will go
straight into the Installation Guide menu. (This
screen only appears when the television is turned
on for the rst time.)
5. Press
buttons to select your desired OSD
language: English/Simplied Chinese/Traditional
Chinese.
6. Press
buttons
to select Auto Tuning and then
press OK button to start auto tuning. After tuning,
the screen will show the rst DTV channel.
OPERATION
Turning the television on for the First Time
Installation Guide
Auto Tuning
English
Language/語言
Channel Setting
1. Press MENU button to display the MENU screen,
and then press
buttons to select "CHANNEL".
2. Press buttons to select the following channel
options and then press OK.
3. Press
buttons to adjust each option’s
setting.
4. Press MENU button to return to the previous
menu.
5. Press EXIT button to exit the menu.
• Auto Tuning
Search all the channels automatically. Press OK
button.
Note:
It will start the DTV tuning rstly, if you want to skip
the DTV tuning, press MENU button to interrupt
the tuning and go to ATV tuning.
All the stored channels will disappear after auto
tuning.
After auto tuning, the television will show the
contents of the rst DTV channel.
• DTV Manual Tuning
You can select a DTV channel, and then nd the
program in this channel.
Press
buttons to change the channel number
or input the channel number. Press OK button to
search the programs.
Note:
Bad, Normal and Good means signal intensity.
• ATV Manual Tuning
Press
buttons to select the channel number
for manual tuning. Press buttons to select
“Search” or “Fine Tune”, and then press
buttons
to conrm.
Auto Tuning
DTV Manual Tuning
ATV Manual Tuning
Programme Edit
Signal Information
CHANNEL
Channel Tuning
ATV : 0 Programme(s)
1 % UHF CH 21 (DTV)
DTV : 0 Programme(s)
MENU
Skip
EXIT
Exit
DTV Manual Tuning
UHF CH 21
+
NO SIGNAL
Bad Normal Good
ATV Manual Tuning
Storage To 1
+
Frequency 867.75 MHz
System I
Current CH 1
Search
Fine-Tune
Save MENU
LC-40LE433H (SHARP香港 SY13050) 說明書英文R5.indd 11 2013-4-3 9:43:24