Watching TV
Selecting audio language
E DTV/CADTV/SAT mode:
Each time you press 2 the audio language switches
between audio sources available.
NOTE
• The audio mode screen disappears in three seconds.
• Selectable items vary depending on the received
broadcasts.
E ATV mode:
Each time you press 2, the mode switches as shown
in the following tables.
NICAM TV broadcasts selection
Signal Selectable items
Stereo
NICAM STEREO, MONO
Bilingual
NICAM CH A, NICAM CH B, NICAM CH AB, MONO
Monaural
NICAM MONO, MONO
A2 TV broadcasts selection
Signal Selectable items
Stereo
STEREO, MONO
Bilingual
CH A, CH B, CH AB
Monaural
MONO
NOTE
• When no signal is received, the audio mode will display
“MONO”.
E DTV/CADTV/SAT mode:
Press SUBTITLES [ button to change between
different languages available, or to enabled/disabled
the subtitles.
E ATV mode:
The available subtitles according to the broadcasting
will be enabled or disabled by pressing the SUBTITLES
[ key.
E Press “ATV”, “DTV”, "SAT" or "RADIO" to
change between modes.
Daily operation
Switching on/off
Press a on the TV to switch it on.
Switch it off by pressing a on the TV.
Standby mode
E Switching to standby mode
If the TV is switched on (BLUE LED), you can switch
it to standby by pressing TVa on the remote control
unit.
E Switching on from standby
From standby (RED LED), press TVa on the remote
control unit.
TV indicator status
LED indicator Status
Off
Power off
Blue
Power on
Red
Standby
Violet
StandBy with USB REC programmed
NOTE
• If you are not going to use this TV for a long period of time,
be sure to remove the AC cord from the AC outlet.
• A small amount of electric power is still consumed even
when a is turned off.
Switching between digital, satellite
and analogue broadcasts
Changing channels
With 0–9:
With Pr/s:
Selecting an external video source
Once the connection is made,
press b to display the
“Source List” screen,
and then press a/b to
switch over to the appropriate
external source with OK.
Switching subtitle languages
Turning on/off the power
10
NOTE
• When turning off the power
using a on the TV, EPG
data will be lost.
• The terminal layout may differ
depending on the model.
AVF
To Next Page
Loading...
Need help?
General