Sharp LC-52LE920UN - LED Flashing Specification at the Time of an Error (Center Icon LED Used)

LC-52LE920UN/LC-60LE920UN
| Trouble Shooting Panel Module
+
| When C-S FPC(2 pieces) is replaced, does screen display normally?
‘ YES
| Replace C-S FPC(2 pieces).
NO
When C-PWB is replaced, does screen display normally?
' YES
Replace C-PWB.
(Adjust “VCOM ADJ” after replace C-PWB)
NO
Replace Panel HIRAKI.
(Adjust “VCOM ADJ” after replace Panel HIRAKI)
[2] LED flashing specification at the time of an error (Center icon LED used)
1. Display method
« Since only the center icon LED can be used, slow flashing and fast flashing are combined.
+ Refer to Table 1.
+ The Start from the detail display. (No outline display)
+ After recovering from an error, if the same error cannot be generated again, refer to MONITOR ERR CAUSE on the process screen.
+ During version upgrade, the brightness of the flashing LED changes smoothly.
«+ When completing version upgrade, the brightness of the LED changes in a staircase pattern.
2. LED flashing method
Error flashing
<Detail display example>
Center icon
1 1600ms
+ Flashing during Verup
Center icon Qa wn ane
’ Y “f OFF
i
500ms
+ Flashing when completing Verup
Center icon ood Sconnonaonann ——
fo
4000ms 1000ms 1000ms 4000ms
6-14