Using the HDMI CEC (Consumer Electronics Control) protocol, with AQUOS LINK you can
interactively operate compatible system equipment (Blu-ray disc equipment, AV amplifier, DVD).
By connecting AQUOS LINK-compatible devices with HDMI-certified cables to the TV, you can
control a recorder or AV amplifier using the remote control of the TV.
AQUOS LINK allows you to operate the HDMI-connected equipment with one remote control.
NOTE
(UQ/TQ/SQ series) Connect 4K signals (HDCP2.2) to the HDMI IN 1 terminal. These signals
will not be displayed if connected to the HDMI IN 2, 3, or 4 terminals.
For connecting the TV to AQUOS LINK-compatible equipment, use commercially available
cables.
Point the remote control toward the TV, not to connected HDMI equipment.
Video noise may occur depending on the type of HDMI cable used. Make sure to use an HDMI-
certified cable.
Up to 3 pieces of HDMI recording equipment and one AV amplifier can be connected using this
system.
These operations affect the HDMI equipment selected as the current input source. If the
equipment does not operate, turn on the equipment and select the appropriate input source
using INPUT.
The AQUOS LINK feature may not operate properly when an HDMI splitter or AV selector unit
is used. These devices may cause interruptions to the image and/or sound.
One Touch Play
While the TV is in standby mode, it automatically turns on and plays back the image from the
HDMI source.
Single remote control
The AQUOS LINK automatically recognizes the connected HDMI device and you can control the
TV and the devices as if using a universal remote control.
Control the AQUOS LINK-compatible audio system
Set the volume of AQUOS LINK-compatible audio system.
NOTE
The above description is an example of the AQUOS LINK function.
The steps in "AQUOS LINK Setup" on
page 7-2 need to be completed beforehand.
Refer to this operation manual and the operation manual of the AQUOS LINK device to be used
with this TV.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
