11
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Preparation for Use
- Remote Control -
MD-E9000H
■ Battery installation
1. Remove the battery cover.
2. Insert the batteries according to the direction indicated in the bat-
tery compartment.
When inserting or removing the batteries, push them towards the ë ter-
minals.
3. Replace the cover.
Precautions for battery use:
● Replace all old batteries with new ones at the same time.
● Do not mix old and new batteries.
● Remove the batteries if the unit will not be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
● Do not use rechargeable batteries (nickel-cadmium battery, etc.).
● Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
● Replace the batteries if the operating distance is reduced or if the operation be-
comes erratic. Purchase 2 “AAA” size batteries (UM-4, R03, HP-16 or similar).
● Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
● Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
● Keep the remote control away from moisture, heat, shock, and vibrations.
■ Test of the remote control
Face the remote control directly to the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy the
music.
Remote Control
0.2 m - 6 m
(8" - 20')
Remote sensor
11
12
10
9
8
6
7
5
4
3
2
1
*MD9000H-E10-11 2001.4.20, 2:02 AM11
To Next Page
Loading...
Need help?
General
