35
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
MD Recording
- Recording to a MiniDisc from the Radio -
MD-E9000H
Recording to a MiniDisc from the Radio
1 Tune in to a desired station (see page 22).
2 Load a recordable MiniDisc.
3 Select a recording mode by pressing one of the REC MODE but-
tons (SP, LP2, LP4).
● At the same time, you can check the recordable time of the MD.
4 Press the REC button.
● The unit will enter the recording stand-by mode.
5 Press the MD
0606
0606
06
button.
Notes:
● Before recording an AM broadcast, enter the recording stand-by mode, and then
separate the AM loop aerial from the main unit. Adjust it so that the AM broadcast
can be tuned in most clearly.
● During recording, you cannot change stations.
To interrupt recording:
Press the MD
06
button.
To resume recording, press the MD 06 button again.
To stop recording:
Press the MD ■ button.
The recording will stop and the track number will be written on the MiniDisc.
To record the track number whilst recording:
The recording is performed as a single track.
To identify different sections of a recording, you can increase the track number at
any point during the recording process by pressing the REC button.
● The track number will increase by one, and then the recording will continue.
11
12
10
9
8
6
7
5
4
3
2
1
*MD9000H-E31-35 2001.4.20, 2:13 AM35
To Next Page
Loading...
Need help?
General
