Sharp MD-E9000H - To automatically play the desired programme (EON-PTY)

28
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
RDS Radio
- Using the Radio Data System (RDS) -
■ To automatically play the desired programme
(EON-PTY)
When the desired type of programme is broadcast, the radio switches to it automati-
cally.
1 Tune in to an RDS station (when a station name is displayed).
2 Press the EON button when “EON” appears.
● “PTY TI” will flash for about 4 seconds.
● If the EON button is pressed when “EON” is not displayed, “NO EON” will
appear for 4 seconds to indicate that the unit cannot enter the EON stand-
by mode.
3 Whilst they are displayed, select the desired programme type by
pressing the
5/35/3
5/35/3
5/3
or
2/42/4
2/42/4
2/4
button.
The selected programme type will flash.
4 Within 4 seconds, press the PTY. TI button.
● The selected programme type and “WAITING” will be displayed for 2 sec-
onds each.
● “PTY” will appear, and the unit will enter the EON-PTY stand-by mode.
Using the Radio Data System (RDS) (continued)
5 When the specified programme starts on an ON (other network)
station, the unit will automatically switch to the station and “PTY”
will flash.
6 When the programme is over, the unit will automatically return
to the original station.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button. (“Programme type” → “WAIT-
ING”)
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within 4 seconds, press it
again. (“PTY” will go out.)
*MD9000H-E24-30 2001.4.20, 2:11 AM28