Sharp MD-MT170E - Titling a Minidisc

01/10/26 MD-MT170E_5.fm
29
MD-MT170E
Advanced Features
-Titling a MiniDisc-
Titling a MiniDisc
 Creating disc and track names
Load a MiniDisc to be named. A playback only or record-
ing prevented MiniDisc cannot be edited.
1
<Disc name> <Track name>
Whilst in the stop
mode, press the
MENU/CHRG button to
select "EDIT".
Whilst in the pause
mode, press the
MENU/CHRG button to
select "EDIT".
2
Press the ENTER/SYNC button.
3
<Disc name> <Track name>
Press the MENU/CHRG
button to select "DISC
NAME".
Press the MENU/CHRG
button to select
"TRACK NAME".
4
Press the ENTER/SYNC button.

The unit will enter the character input mode.

To cancel the operation, press the :OFF/HOLD
button.
5
Press the button repeatedly to select the
type of characters.
Cursor
The first 3 characters in the group of the selected
characters will be displayed for about 1 second.
6
Press the or button repeatedly to se-
lect the letter.
7
Press the ENTER/SYNC button to enter it.
Position where the next letter will be entered
8
To enter more letters, repeat steps 5 - 7.
9
When the name has been completely en-
tered, press the MENU/CHRG button.

"TOC" will be displayed. To write the updated con-
tents to the MiniDisc, press the :OFF/HOLD but-
ton.

You cannot remove the MiniDisc whilst "TOC" is
displayed. "TOC" will not disappear until the re-
corded contents have been updated.
Note:

Complete the operation within 7 seconds whilst se-
lecting the menus.
(Capital letters) (Lower-case letters) (Numbers and symbols)