Sharp MD-MT170E - Using with the AC Adaptor

01/10/26 MD-MT170E_2.fm
9
MD-MT170E
Power Source
-Using with the AC Adaptor-
 About charging time
After about 3.5 hours have passed, " " will
go out. The battery is charged up to 90% if it is
completely discharged.
To charge the battery fully, continue charging for about 2
more hours. In this case, you do not need to press the
MENU/CHRG button. Even if the MENU/CHRG button is
pressed, " " will not appear.
Notes:
Caution:
Using with the AC Adaptor
Plug the AC adaptor into the wall socket, and then insert the
plug on the other end into the DC IN 5V socket.
Caution:

Insert the plugs firmly.

When the unit is not in use for extended periods, remove
the AC adaptor from the wall socket.
Note:

If power failure occurs whilst playing a disc using the AC
adaptor, disconnect it from the wall socket. Otherwise,
playback may start automatically when the electricity sup-
ply resumes.

Charge the battery within the
range of 5°C - 35°C (41°F - 95°F).

The unit can be left in the charg-
ing state after it is completed.

Carry the battery in the supplied
case. Apply the case on the end.

Use the specified battery AD-N55BT only. Do not
charge a battery (nickel-cadmium, alkaline, etc.) other
than that specified.

Do not remove the outer cover of
the rechargeable battery. It may
cause heat generation, fire, or ex-
plosion.

Do not dip the battery in water, do
not dispose of it in a fire, and do
not take it apart.

If the rechargeable battery terminal is dirty, charging
may not start. In such a case, wipe off the dirt with a
dry cloth.

Do not disassemble the battery.
AC 230V, 50/60Hz
To the DC IN 5V socket