Sharp MD-MT270H - Recording

02/11/7 MD_MT270H_SEEG_E3.fm
E-10
MD-MT270H
ENGLISH
Basic Operation
-Recording-
Notes:
! Complete the operation within 7 seconds whilst selecting
the menus.
! Changing the volume level whilst recording does not affect
the recording.
! You cannot adjust the bass level whilst recording.
To interrupt recording
Press the button.
! To resume recording, press the button again.
! The track number will be increased by one each time the
recording is interrupted.
To stop recording
Press the :OFF/HOLD button.
Notes:
! Whilst "TOC" is displayed, the MiniDisc recorded contents
are not yet updated.
! To prevent the new recording from being lost, it is not pos-
sible to remove the MiniDisc whilst "TOC" is displayed.
To update the recorded contents of the Mini-
Disc
Press the :OFF/HOLD button whilst in the stop mode.
The power turns off after recorded contents have been
updated on the MiniDisc.
5
Press the MENU/ENTER button.
6
Press the or button repeatedly to select "REC
MODE".
7
Press the MENU/ENTER button.
8
Press the or button repeatedly to select the
recording mode (page 15).
9
Press the MENU/ENTER button.
The mode will be set automatically after 7 seconds even
if the MENU/ENTER button is not pressed.
10
Press the button to start the MiniDisc unit re-
cording.
11
Begin playback on the stereo system, the output
will be recorded.
SP
(2 times long recording)
(4 times long recording)
(Monaural recording)
(Stereo recording)
TOC display