02/11/7 MD_MT270H_SEEG_E6.fm
E-35
MD-MT270H
ENGLISH
References
-Error Messages-
Error Messages
A number or symbol appears in (*) position.
ERROR MES-
SAGES
MEANING
BATT EMPTY " The battery has run down.
BLANK MD " Nothing is recorded.
(Replace the disc with a recorded disc.)
Can't COPY " You tried to record from a copy prohib-
ited MiniDisc.
(Record using the analogue cable.)
" You tried to record signals other than
music (such as data).
Can't EDIT " A track cannot be edited.
(Change the stop position of the track and
then edit it.)
Can't PLAY " You tried to play back a track that can-
not be played with this equipment.
Can't READ (*) " The disc data cannot be read because
the disc is damaged.
(Reload the Minidisc or replace it with an-
other one.)
Can't REC " Recording cannot be performed cor-
rectly due to vibration or shock.
ERROR MES-
SAGES
MEANING
Can'tSTAMP " Stamp function does not work.
(Check the number of tracks.)
Can'tWRITE " Cannot save the TOC information cor-
rectly to a MiniDisc.
DEFECT! " The disc is scratched.
(If the recorded sound is not right, retry re-
cording or replace the disc with a record-
able one.)
DISC FULL " The disc is out of recording space.
Er-MD (**) " The microprocessor has reported a
system fault and the unit is out of order.
(To have it repaired, go to the distributor
where you purchased the unit.)
HOLD " The unit is in the hold mode.
LOCKED " You removed a MiniDisc whilst record-
ing or editing.
(Turn off the power before removing the
MiniDisc.)
NO DISC " A disc has not been loaded.
To Next Page
Loading...
