02/11/7 MD_MT270H_SEEG_E3.fm
E-12
MD-MT270H
ENGLISH
Basic Operation
-Playback-
" Bass control
Each time the BASS/SYNC button is pressed, the bass
response will be switched as follows.
" To adjust the bass response
You can set 3 types of bass settings (BASS 1 - BASS 3) by
adjusting low (Lo) and high (Hi) boost for each setting.
Notes:
! If you set the volume more than 23, the bass boost will be
adjusted automatically.
! When the bass sound is emphasised with the volume
level set higher than 23, the volume level will be reduced
to 22 automatically.
BASS 1 Emphasised slightly.
BASS 2 Emphasised more.
BASS 3 Emphasised fully.
BASS OFF Cancelled. (Default setting)
1
During playback, press the MENU/ENTER button.
2
Press the or button repeatedly to select
"SOUND ADJ".
3
Press the MENU/ENTER
button.
4
Press the or button
repeatedly to select bass
setting.
B: bass selection
5
Press the VOL + or VOL -
button to select the bass
selection from "B1" to
"B3".
(Example: to change
"BASS 3")
B1 to B3
6
Press the or button
repeatedly to select "Lo".
Lo: low sound setting
7
Press the VOL + or VOL -
button to adjust the low
sound setting.
1 to 5 (default setting:3)
8
Press the or button
repeatedly to select "Hi".
Hi: high sound setting
9
Press the VOL + or VOL -
button to adjust the high
sound setting.
1 to 5 (default setting:3)
10
Repeat steps 4 - 9 to change the other bass setting.
11
When the bass selection is entered, press the
MENU/ENTER button.
To Next Page
Loading...
