Sharp MX-2614N

TEST SIMULATION
SHARP
44
22
Data Output & Check
11
Fax counter display
12
RSPF jam history display
13
Process cartridge counter display
14
Toner cartridge use status
18
User data delete history
19
Image Send counter display
25
Toner usage estimator data display
40
Error code list display
90
System setting list print
23
Data Print Mode & Check
2
Print jam/Trouble data print mode
80
Data print mode (paper feed)
24
Data Counter & Clear
1
Jam/trouble counter clear
2
Paper feed counter clear
3
Document feed & output counter clear
4
Maintenance counter clear
5
Developer counter clear
6
Copy Counter clear
9
Print & other counter clear
10
Fax counter clear
15
Network scanner counter clear
25
Toner usage estimator counter clear
35
Toner cartridge use status clear
25
DV Auto Adjustment & Monitor
1
Toner sensor monitor (Process drive)
2
Auto developer adjustment setting
4
Toner supply quantity data display
5
Toner density correction data display
26
Device Configuration
1
Right Tray setup
3
Auditor setup
5
A3 Total/Maintenance counter set-up
6
Destination set-up
7
Machine ID setting
8
Long paper mode counter setting
10
Network scan trial mode set-up (MX-AMX1)
18
Toner save operation
30
CE mark control setup
32
Fusing cleaning operation setting
35
Trouble memory mode setting
38
Engine life over setting (Maintenance)
41
Pamphlet mode AMS operation
26
Device Configuration
49
Copy speed mode setup (Postcard)
50
Function setting: (B/W reverse, Colour
mode, Finisher, Long Size print, Wireless
set etc).
51
Serial port operation setting (for PCI)
52
Blank paper count mode setting (non
printed paper – insert/cover page)
53
Enable/Disable auto colour calibration
65
Finisher staple alarm mode set-up
69
Toner near end setting
73
Poster enlargement image loss adjustment
74
OSA trial mode setting
78
Remote operation (VNC) password setting.
79
User data delete pop up display
enable/disable
30
Sensor Operation & Test
1
Main unit sensor check
2
Paper feed sensor check (main body)
33
IDM Data Clear
2
Felica card ID (IDM) information deletion
40
Bypass Operation & Adjustment
2
Bypass tray width adjustment
7
Bypass tray width detection manual setting
41
OSS Operation & Adjustment
1
Document sensor operation check
2
Document sensor output setup
3
Document sensor output display
43
Fuser Setting & Adjustment
1
Fuser temperature setup for each mode
4
Fuser temperature 2. setup for each mode
20
Fuser temperature. correction for low
temperature & humidity (L/L)
21
Fuser temp correction for high
temperature & humidity (H/H)
22
Perform L/L correction for fuser
temperature setting
23
Perform H/H correction for fuser
temperature setting
24
Fuser temperature correction setting
31
Fuser web operation check
32
Force operation of web cleaning (job end)