Sharp MX-2614N

SHARP
TEST SIMULATION
45
44
Process Control Data
1
Process control mode setting
2
Process control sensitivity adjustment
4
Process control initial density setup
6
High density process control correction
9
Process control data display
12
DM data, patch/base data display
14
Fuser temp.& humidity output data
15
OPC drum idle rotation setting
21
Half tone process control registration
22
Half tone process control patch result
24
Half tone correction data result display
25
Initial half tone correction data display
26
Half tone process control execution
27
Half tone process control correction clear
28
Process control timing (On/Off) setting
29
Enable/disable half tone correction during
each job
31
OPC drum deflection adjustment/check
37
DV bias correction level setting for
continuous print mode.
43
DV unit installation identification check
62
Process control execution condition setting
46
Copy & Image Density Adjustment
1
Colour copy density adjustment
2
B/W copy density adjustment
4
Colour scanner density adjustment
5
B/W scanner density adjustment
8
Colour scanner balance adjustment RGB
9
Scan image density adjustment
10
Copy colour balance & gamma manual
adjustment
16
Monochrome copy density & gamma
adjustment
19
B/W auto exposure mode setup
21
Engine colour balance adjustment (All)
23
Enable/disable maximum density adjust.
24
Engine half tone auto adjustment
25
Single colour mode colour balance set-up
26
Single colour mode colour balance reset
27
Coefficient (Black edge) gamma set-up
30
Resolution adjust (sub-scan – copy mode)
32
Document background density adjust.
36
2-colour mode adjustment (Red, Black)
37
B/W image reproduction adjustment
38
Black component adjustment (Copy mode)
39
Fax Image send sharpness adjustment
46
Copy & Image Density Adjustment
40
Fax mode exposure adjust (All modes)
41
Fax mode exposure adjust (Normal)
42
Fax mode exposure adjust (Fine Text)
43
Fax mode exposure adjust (Super Fine)
44
Fax mode exposure adjust (Ultra Fine)
45
Fax mode exposure adjustment (600dpi)
47
JPEG compression rate setting
51
Heavy paper mode gamma adjustment
52
Heavy paper mode gamma default set
54
Half tone density adjustment (dither).
58
Copy mode pseudo resolution setting
(smoothing process).
59
Copy mode pseudo resolution image
process adjustment.
60
Sharpness adjustment (colour auto mode)
61
Area separation recognition setting
62
ACS operating condition setting
63
Copy low density adjustment
65
Colour correction table setting.
74
Copy colour balance adjustment
48
Magnification & Motor Adjustment
1
Scan image magnification ratio adjust
(Main scan)
5
Scan image magnification ratio adjust (Sub
scan)
6
Motor rotation speed adjustment
49
Firmware & E-Manual Upgrade
1
Firmware Upgrade Program
3
E Manual Update Program
5
Watermark Update Program
50
Image Position Adjustment
1
Lead edge/copy position adjustment
5
Printer lead edge adjustment (sub scan)
6
DSPF Lead edge/copy position adjustment
10
Print off-centre deviation adjustment.
12
Original centre deviation adjustment.
20
Manual colour registration adjustment.
22
Auto colour registration & drum
adjustment
24
Auto registration & drum data display
27
Image loss adjustment (Fax/Scanner)
28
Service adjustment (OC/SPF position)